Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DS3 bouncing

any one have an Idea why DS3 will be acting this way

Thanks

Feb  1 12:40:59.560: %ENTITY_ALARM-6-INFO: ASSERT MAJOR Se4/0 Receiver has remote alarm

Feb  1 12:41:01.560: %LINK-3-UPDOWN: Interface Serial4/0, changed state to down

Feb  1 12:41:01.560: %ENTITY_ALARM-6-INFO: ASSERT MAJOR Se4/0 Physical Port Link Down

Feb  1 12:41:01.560: %ENTITY_ALARM-6-INFO: CLEAR MAJOR Se4/0 Receiver has remote alarm

Feb  1 12:41:01.560: %ENTITY_ALARM-6-INFO: CLEAR MAJOR Se4/0 Physical Port Link Down

4 REPLIES
Hall of Fame Super Gold

Re: DS3 bouncing

Because the remote is sending remote alarm. So check the remote to know why.

New Member

Re: DS3 bouncing

the only thing that I c different is that the remote side on the int level there is no keepalive, everyting else is ok.. could it be the reason why it bounsing ?

Hall of Fame Super Gold

Re: DS3 bouncing

No.

However you should have keepalive unless proven otherwise.

Silver

Re: DS3 bouncing

Call the ISP to find out why the circuit is bouncing.

I would also check the interface for any errors, it could be taking a lot of errors and causing it to go down, however, in the logs it shows remote side so chances are it is an issue with the ISP side.  If they push back as them to install a DS3 monitor inline.  This works much like a packet capture.

444
Views
0
Helpful
4
Replies