cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
481
Views
0
Helpful
1
Replies

DS3 Connection

angel-moon
Level 3
Level 3

Hello Everyone,

with an NM-1T3/E3 Netowkr module other than issuing the card type command, assiging an IP address and issuing the no shut command on the now created Serial interface is there anything else that needs to be done to bring up a DS3 connection?

Thanks in advance! ALl replies rated

1 Reply 1

Collin Clark
VIP Alumni
VIP Alumni

The DSU bandwidth and framing are critical. Here's an exmaple of my interface config.

interface Serial2/0

description [Circuit ID]

ip address a.b.c.d 255.255.255.252

no ip proxy-arp

encapsulation ppp

ip route-cache flow

ntp disable

dsu bandwidth 40300

framing c-bit

cablelength 250

serial restart-delay 0

no cdp enable

Hope that helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco