Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DS3/E3: G.832 FEBE errors

Hi Team,

i continue to see an increment in

DS3/E3: G.832 FEBE errors

telco, tested several times, and my HW was replaced, chassis, DS3 CARD, and cable too... please see ATTACHED config, and output of DS3/E3: G.832 FEBE errors, any other thoughts.

IOS is:

12.4.6.T7

CHASSIS: 3845, AIM-1A-T3

Thanks

2 REPLIES
Silver

Re: DS3/E3: G.832 FEBE errors

FEBE errors are "Far End Block Errors" You may want to check the physical cable or check the provider end equipment And ensure frequency match between the this end and the far end devices. This document provides troubleshooting tips for ATM over digital signal level 3 (DS-3) and E3 router interfaces.

http://www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a0080111093.shtml

Hall of Fame Super Gold

Re: DS3/E3: G.832 FEBE errors

Do the errors come in burst of uniformly ?

Has telco made a 24h BER test ?

1418
Views
0
Helpful
2
Replies