I am having Zyxel P-660HW series ADSL router. ISP has configured the PPP type in that ADSL router with static IP. I want to configure the Static IP address in my Cisco 1841 router which is directly connected to ADSL ( Zyxel) router. I tried to configured the bridge mode in ADSL router and I configured the Static IP address in Cisco router but no luck. Please any one me out .
I am not using ATM interface, I want configure the bridge mode in Ztxel router and then I need to configure the IP address in Cisco router. Already I tried to configure the Bridge mode in ADSL router but its not working . please find the configuration
If I can understand correctly you want to configure the zyxel router in bridge mode and the associated public ip on the cisco router.
Then you need to run the setup on zyxel router and change the mode to brdige and ofcourse check the VPI and VCI.I think it should be 1 and 32.
Now once you are through with that check the public ip with mask and gateway on a test machine and try to get to run the internet.You are now with public ip and can configure the 1841 router.In such type of setups the duplex speed mismatch may not allow the internet to work.Check on that part with your isp as on my experience auto on the interface from zyxel to cisco never detect the exact duplex speed.
Correct. I got the VPI and VCI details( 8 and 32) and Encap from ISP So in have configured the Zyxel router in bridge mode and I configured the IP address in Cisco router but no luck. For your reference I am pasting the configuration.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...