Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

DSL controller problem

Hi,

I've a problem with my DSL controller, I configured this one but the controller is flapping UP-DOWN-UP-DOWN, I tried several parameters but still NOK, have you an idea why? Thanks in advance.

HERE's my config.

controller DSL 0/0/0

mode atm

line-term cpe

line-mode auto

dsl-mode shdsl symmetric annex B

Do it can be due to the firmware on the controller?

4 REPLIES
Hall of Fame Super Gold

Re: DSL controller problem

When reporting problems, at the minimum, always include router model and exact IOS used.

Community Member

Re: DSL controller problem

Sorry, here's more info. :

Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(17a), RELEASE SOFTWARE (fc)

Cisco 2811 (revision 53.50) with 251904K/10240K bytes of memory.

Processor board ID FCZ120273RJ

1 DSL controller

2 FastEthernet interfaces

4 ISDN Basic Rate interfaces

1 ATM interface

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Community Member

Re: DSL controller problem

Router#sh controllers dsl 0/0/0

DSL 0/0/0 controller DOWN

SLOT 0: Globespan xDSL controller chipset

DSL mode: Not Trained

Frame mode: Utopia

Configured Line rate: 4608Kbps

Line Re-activated 53 times after system bootup

LOSW Defect alarm: ACTIVE

CRC per second alarm: ACTIVE

Line termination: CPE

FPGA Revision: 0xB2

Line 0 statistics

Current 15 min CRC: 0

Current 15 min LOSW Defect: 0

Current 15 min ES: 0

Current 15 min SES: 0

Current 15 min UAS: 180

Previous 15 min CRC: 0

Previous 15 min LOSW Defect: 0

Previous 15 min ES: 0

Previous 15 min SES: 0

Previous 15 min UAS: 871

Line 1 statistics

Current 15 min CRC: 0

Current 15 min LOSW Defect: 0

Current 15 min ES: 0

Current 15 min SES: 0

Current 15 min UAS: 203

Previous 15 min CRC: 0

Previous 15 min LOSW Defect: 0

Previous 15 min ES: 0

Previous 15 min SES: 0

Previous 15 min UAS: 737

Line-0 status

Chipset Version: 0

Firmware Version: R3.0.1

Modem Status: Handshake, Status 10

Last Fail Mode: No Failure status:0x0

DSL firmware download in progress, please wait

Line-1 status

Chipset Version: 0

Firmware Version: R3.0.1

Modem Status: Handshake, Status 10

Last Fail Mode: No Failure status:0x0

DSL firmware download in progress, please wait

Dying Gasp: Present

Hall of Fame Super Gold

Re: DSL controller problem

Hi,

I don't think it's normal that you have "DSL firmware download in progress, please wait".

If you upgrade to at least to 12.4(6)T, this will give you latest 3.0.5 firmware, as explained at:

http://cisco.com/en/US/prod/collateral/routers/ps221/prod_bulletin0900aecd801d5c4c.html

1612
Views
3
Helpful
4
Replies
CreatePlease to create content