You only show the configuration of one side of your senario. Also you show a DLSW connection established because the remote IP and local IP see each other and the DLSW protocol is talking to both end points, however the actual non routable traffic (SNA, other) is not established. You probably need to activate the remote end host systems (Activate the addresses and or major nodes on both ends). This will establish your DLSW circuits....
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.