router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start % Not enough DSP resources available to configure ds0-group 1 on controller T1 0 /0/0 % The remaining dsp resources are enough for 14 time slots. % For current codec complexity, 2 extra 16 channel dsp(s) are required to create this voice port.
does that mean I've to buy 2 extra 16 channel dsp(s)to create 24 channels?
even though I bought following modules:
32-channel high-density voice and video DSP module
1-Port 2nd Gen Multiflex Trunk Voice/WAN Int. Card- T1/E1
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...