Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DTE V.11 (X.21) clocks stopped

I have my int s0/0/0 down/down

with the sh cont result above.

I suspect the NTU is just not active,

is there any possible problem aside from that?Any possible configuration with my

interface???if there is, how can I pssobly fix it remotely???

Thanks

5 REPLIES
Hall of Fame Super Gold

Re: DTE V.11 (X.21) clocks stopped

You cannot reset/fix an NTU remotely. As improvment you can eliminate and replace with an E1 interface. Advantage is that you will be able to see real circuit performance and status.

New Member

Re: DTE V.11 (X.21) clocks stopped

i did not mean the NTU.

I meant the CE itself, if there's any possible

problem wit the config.

BTW, I disabled the keep alive on the interface and it remained down/down.

I guess that means I have a broken WIC.

Right????

Thanks

Hall of Fame Super Gold

Re: DTE V.11 (X.21) clocks stopped

No, usually these problems are due to bad cabling and faultiy circuits. You can shut/no shut the interface, but more likely as I mentioned, the router is not defective.

New Member

Re: DTE V.11 (X.21) clocks stopped

we have it tested it already clean up to

NTU from the NW provider.

when you disable the keep alive on an interface,

shouldn't it come up if the interface card has

no problem????

maybe bad V.11 cable though.....

thanks

Hall of Fame Super Gold

Re: DTE V.11 (X.21) clocks stopped

Interface dis down p because control leads are down, as you can see that with show controller.

724
Views
0
Helpful
5
Replies