Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Dual home FEX and VPC question

hello,

We have to N5K with N2K fex's. We are dual homing the fexs to the N5Ks setting up VPC between the two N5Ks and the each fex.  Is it normal to see every interface on each FEX as   part of a VPC?

See output below:

RchA02NccSfNx01(config-if)# sho vpc

Legend:

(*) - local vPC is down, forwarding via vPC peer-link

vPC domain id : 1

Peer status : peer adjacency formed ok

vPC keep-alive status : peer is alive

Configuration consistency status : success

Per-vlan consistency status : success

Type-2 consistency status : success

vPC role : primary

Number of vPCs configured : 133

Peer Gateway : Disabled

Dual-active excluded VLANs : -

Graceful Consistency Check : Enabled

Auto-recovery status : Disabled

vPC Peer-link status

---------------------------------------------------------------------

id Port Status Active vlans

-- ---- ------ --------------------------------------------------

1 Po1 up 1-2,9,17,197

vPC status

----------------------------------------------------------------------------

id Port Status Consistency Reason Active vlans

------ ----------- ------ ----------- -------------------------- -----------

101 Po101 up success success -

102 Po102 up success success -

103 Po103 up success success -

104 Po104 up success success -

105 Po105 down* Not Consistency Check Not -

Applicable Performed

102400 Eth101/1/1 down* Not Consistency Check Not -     <-----------We did not create a vpc 102400. Is this normal for a dual home configuration?

Applicable Performed

102401 Eth101/1/2 down* Not Consistency Check Not -

Applicable Performed

102402 Eth101/1/3 down* Not Consistency Check Not -

Applicable Performed

102403 Eth101/1/4 down* Not Consistency Check Not -

Applicable Performed

102404 Eth101/1/5 down* Not Consistency Check Not -

Applicable Performed

102405 Eth101/1/6 down* Not Consistency Check Not -

Applicable Performed

1 REPLY
New Member

Dual home FEX and VPC question

Hi I asked Cisco a while  ago the same question... the response was:

"As for VPC number 201728 and higher, this is normal behavior when you configure on N5K FEX fabric ports as vPCs."

Regards

François

177
Views
0
Helpful
1
Replies
CreatePlease to create content