if you want all spokes to use the same hub router as primary, I think it is easier to achieve this with two different DMVPN clouds so that you can play on IGP metric at muitipoint GRE tunnel level at spokes and on the hub routers.
A link to the solution reference network design for DMVPN
I need same HUB router as primary and I am running eigrp..
Here is a thought that needs clarification:
If I apt single cloud Dual HUB DMPVPN, can I use an offset list on the tunnel interface of the secondary DMVPN HUB router to make all the routes advertised through this hub mgre interface to be worse for the spokes?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...