Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dual ISP load balance on 1841

Hi Netpros,

I need to terminate a broadband and a leased line on 1841, for load balancing / failover with NATting.

Is it possible, if yes, then how?

Thanks & Regards,

Sauarbh Garg

+919819313892

4 REPLIES

Re: Dual ISP load balance on 1841

Hi Saurabh

You can do outbound load balance but on the incoming part you are not left with any option of load balancing.

so better to stay away from doing this which may even deteriorate the performance of the outbound traffic too..

regds

New Member

Re: Dual ISP load balance on 1841

Hi,

Thanx for the reply.

I would be using another device for NATting, and would be doing load balance on 1841 only. Can you suggest about the kind of QoS to be implemented on this kind of setup?

Thanx

cheers,

saurabh

Re: Dual ISP load balance on 1841

Hi

Since its going to be plain internet access what kinda QoS you want to have over here ?

regds

New Member

Re: Dual ISP load balance on 1841

Hi,

I am sorry for putting on the wrong word.

I was to ask about IP SLAs. This am asking in the case when my router is connecting to broadband modem on ethernet. Then I need SLAs to track the ADSL line. Now, how will my router work for failover, I mean how will it shift to the leased line when the ADSL line goes down??

cheers,

saurabh

226
Views
0
Helpful
4
Replies
CreatePlease to create content