Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dual VWIC-1MFT-E1 on 2811

Here is my issue.

I have two VWIC cards on a 2811 going to 2 providers.

One E1 is going down with errors. Line code violations blablabla, and sometime just by chaging the time on the CCM.

Do I need to configure clock source internal on both controller or source line on one of them ?

many thanks.

  • WAN Routing and Switching
3 REPLIES
Hall of Fame Super Gold

Re: Dual VWIC-1MFT-E1 on 2811

Clock source must be line on both.

You also need network-clock-participate and network-clock-select.

New Member

Re: Dual VWIC-1MFT-E1 on 2811

well ,when I have source line on both, marticipate on both and select either the first one or the second one, then I still have the E1 going down with line code violations.

the only "stable" config is internal on both, participate on both, no select.

But in this config, I have slip erros. no big deal but I don't really understand why it does not work with source line.

Hall of Fame Super Gold

Re: Dual VWIC-1MFT-E1 on 2811

Sometime strange things happen when multiple clocks are in a router.

If you can prove that one circuit at time is 100% stable and clean with line clock, -participate and -select, but two are not, then it would be matter for the TAC to look at.

206
Views
0
Helpful
3
Replies
This widget could not be displayed.