cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
476
Views
0
Helpful
3
Replies

Dual VWIC-1MFT-E1 on 2811

nguyen
Level 1
Level 1

Here is my issue.

I have two VWIC cards on a 2811 going to 2 providers.

One E1 is going down with errors. Line code violations blablabla, and sometime just by chaging the time on the CCM.

Do I need to configure clock source internal on both controller or source line on one of them ?

many thanks.

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Clock source must be line on both.

You also need network-clock-participate and network-clock-select.

well ,when I have source line on both, marticipate on both and select either the first one or the second one, then I still have the E1 going down with line code violations.

the only "stable" config is internal on both, participate on both, no select.

But in this config, I have slip erros. no big deal but I don't really understand why it does not work with source line.

Sometime strange things happen when multiple clocks are in a router.

If you can prove that one circuit at time is 100% stable and clean with line clock, -participate and -select, but two are not, then it would be matter for the TAC to look at.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: