Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Dual Wan Router 1811

Hola MI nombre es Daniel Fiala, Necesito me si me pueden ayudar a resolver la siguiente configuracion, el objetivo final es que desde mi LAN (VLAN1) pueda salir a internet indistintamente por cualquier FA0 u FA1, dando un servicio para comprartir la carga en ambos enlaces.

esta es mi configuracion:

Interface FastEthernet0

description $ADSL$

no ip address

ip tcp adjust-mss 1452

speed auto

half-duplex

pppoe enable

pppoe-client dial-pool-number 1

!

interface FastEthernet1

description $Cable_Modem$

ip address dhcp client-id FastEthernet1

ip nat outside

ip virtual-reassembly

duplex auto

speed auto

!

interface FastEthernet2

!

interface FastEthernet3

!

interface FastEthernet4

!

interface FastEthernet5

!

interface FastEthernet6

description SW_Obra_Social

!

interface FastEthernet7

description SW_Obra_Social

!

interface FastEthernet8

shutdown

!

interface FastEthernet9

shutdown

!

interface Vlan1

description $MICRONET$

ip address 172.28.1.1 255.255.255.0

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1412

!

interface Async1

no ip address

encapsulation slip

shutdown

!

interface Dialer0

ip address negotiated

ip mtu 1452

ip nat outside

ip virtual-reassembly

encapsulation ppp

dialer pool 1

dialer-group 2

ppp authentication pap callin

ppp pap sent-username XXXXXX@speedy password 0 XXXXXX

!

dialer-list 1 protocol ip permit

router rip

version 2

network 172.28.0.0

no auto-summary

!

ip route 0.0.0.0 0.0.0.0 FastEthernet1

ip route 0.0.0.0 0.0.0.0 Dialer0

!

!

ip http server

ip http secure-server

ip nat inside source list 2 interface FastEthernet1 overload

ip nat inside source list ADSL interface FastEthernet1 overload

access-list 2 remark SDM_ACL Category=2

access-list 2 permit 172.28.12.0 0.0.0.255

1 REPLY
Silver

Re: Dual Wan Router 1811

In order to have Load balancing and failover configuration in the router Create the route-map for the nat,Indicate the NAT to connect to the outside,Configure the tracking objects,Indicate the defaults gateway.These steps would help.

126
Views
0
Helpful
1
Replies
CreatePlease to create content