Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

duplex mismatch

sir,

I am getting log in cisco router for sub-interface- duplex mismatch discovered on GigabitEthernet0/1.2 (not half duplex), with SEP00170EF9E8B6 Port 1 (half duplex).

I must have to set duplex and speed auto in interface gi0/1 for other VLAN.

How to solve this.

Plz, help.

Regards,

Tarun

1 REPLY
Hall of Fame Super Silver

Re: duplex mismatch

hello Tarun,

these messages usually are CDP derived.

Another thought is that speed and duplex are physical properties that can be configured only on the physical interface gi0/1.

So a complain for duplex mismatch is a true issue only if it is seen in

sh int gi0/1.

Then the IP phone should be the first device out the port.

In this case you should change the cable or verify cabling it can be a cable issue

or access via web the ip phone page and check for collisions errors or other signs that is putting the link in half duplex.

Hope to help

Giuseppe

496
Views
0
Helpful
1
Replies