Duplex mismathc in remote end (Duplex: half (Mismatch))
There could be many reasons why: bad cable, hard coded on one end and auto on the other, or bad port on either device.
Check the interface configuration on both sides. If you only have access to one side, and it's set to auto, try changing to whatever it's negotiating at while changing the duplex. (If it's negotiated at 100/half, try hard coding at 100/full.) If your side is hard coded, try changing to auto to help the other side negotiate properly. If neither of those work, try a different cable.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.