cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
328
Views
0
Helpful
1
Replies

dynaic route for high latency

shahid_duet
Level 1
Level 1

Dear Boss

I have cisco 2811 at branch and 3845 at Head office. Two link with 256 kbps bandwidthe each. I did as follows:

Interface Tunnel 1

Keep alive 5 4

IP xxxxxxx

Interface Tunnel 2

Keep alive 5 4

IP yyyyyyy

Ip route X.X.X.X tunnel 1

Ip route X.X.X.X tunnel 2 10 

When link 1 down,  traffic change to Tunnel 2. its OK.

I want  when link1 flaxuate or latency high (more than 60 ms)  traffice change to tunnel 2. If link 2 goes high latency automatically  change to tunnel 1.

What can i do for both end  ????

Please help me .

Shahid

1 Reply 1

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

I think OER/PfR supports tunnels, if it does, might be the best solution.  Otherwise, something using SLA interface tracking.

Review Cisco Networking products for a $25 gift card