Hi there! I'm currently trying to setup Dynamic DNS for a home server I'm running so I can update multiple subdomains on it. Unfortunatly after trying multiple way of configuring it I get a Bad parameters error when Debugging is enabled. I have a Cisco 3825 connected to a switch I got to help me learn IOS as I'm working to get a CCNA (I found one for a smoking deal!). However for the life of me I just cannot figure this out. When trying to figure it out I've changed the host= to mc, mcadmin, resrise, and <h> without it working thus far.
Debug shows the following:
*Feb 7 07:23:51.231: DYNDNSUPD: Adding DNS mapping for resrise.manate.ch <=> [External IP] server 220.127.116.11
*Feb 7 07:23:51.231: HTTPDNS: Update add called for resrise.manate.ch <=> [External IP]
*Feb 7 07:23:51.231: HTTPDNSUPD: Session ID = 0x2E
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...