Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 card in the UK

I have a point to point line between our UK and US office. I am pretty sure the config on the US side is good, however, I am not sure about the UK side. I just realized that I may have the wrong card, as British Telecom's equipment is saying that the speed is 1536. I have a VWIC-1MFT-E1 in an 1800 series router but I can't get the serial interface up. I have tried many different configs...am I missing something? Could someone shed some light on this? Thank you very much.

4 REPLIES

Re: E1 card in the UK

Friend,

It seems that the interface provided to you is a T1 and your WIC card is a an E1.

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml

You would either require VWIC-1MFT-G703 or VWIC-1MFT-T1/E1

I always feel that its better to buy a 2gen T1/E1 card (VWIC2-1MFT-T1/E1) rather than just E1 as it can be used for the connections by defining the controller as either T1 or E1

http://www.cisco.com/en/US/products/hw/modules/ps2617/products_configuration_example09186a008052c920.shtml

HTH

Narayan

New Member

Re: E1 card in the UK

That's what I was afraid of. I will double check with BT on Monday.

Thank you.

New Member

Re: E1 card in the UK

hi

we r prety sure that BT is giveing u T1 line .

double check with them, if they also confirum ,

ask them to provide E1 access line and let them do the time slot mapping internally (T1 to E1) , ask them to provide to time-slot

so that u will save the hardware cost

regards

New Member

Re: E1 card in the UK

I will try that, thank you.

113
Views
0
Helpful
4
Replies