Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 configuration for PBX synchronization . . .

Hii,

How to configure E1 . Please do guide me , and also suggest how can we do this for PBX signalling .

I have a Stream from ISP directly terminating from MUX to fast ethernet port0/0 . And i have installed VWIC 1MFT E1/T1 card .

Please suggest on this as it showing me E1 has come up but my PBX showing only layer 1 active , call is getting disconnected after 6-8 seconds. And I don't have any incoming call either .

Thanks in Advance,

Max

1 REPLY
New Member

Re: E1 configuration for PBX synchronization . . .

Do I need to make add any additional commands , what should be the general E1 configuration ?

115
Views
0
Helpful
1
Replies
CreatePlease to create content