Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

E1 configuration problem

Hello I am trying to configure a WAN link using a E1 MFT VWIC2 on a router 3725 when I try to configure the second E1 tyo establish a PPP Multilink I gethe following error message:

%Insufficient resources to create channel group

er-cumana1(config-controller)#

*Mar 9 19:40:56: No Free HDLC resources (0)

I tried to upgrade from 12.2 to 12.3 version cause I only have 32 Mb on flash and 128 on RAM. Not enough to get a 12.4 IP VOICE version.

What do you suggest to solve this issues??

Is there a version that I can use to get both e1 up?

Thanks a lot for your time

1 REPLY

Re: E1 configuration problem

When independent clocking is configured, the controller will support only one channel group. If more than one channel group is configured, the following error message occurs "%Insufficient resources to create channel group"

Router(config-controller)# clock source {line [primary | hits] | internal} [independent]

or check this link for global command "network-clock-participate"

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_command_reference_chapter09186a00800b350b.html#wp1001437

123
Views
0
Helpful
1
Replies