Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 enable

I installed 1 2MFT VWIC card in 2821 router if I command sh ver I see this card detect but sh run command I can?t see it any controller how can I enable it for E1 configuration

Thanks

robin

2 REPLIES

Re: E1 enable

Hi Robin

Can you post the output of show version here ?

Also have you tried configuring card type e1 ?

regds

Re: E1 enable

Hi friend,

I think you are using a version 2 card.

In this case you require the following command

(config)#card type e1/t1

eg. card type e1 0 1

HTH, rate if it does

Narayan

128
Views
0
Helpful
2
Replies
CreatePlease login to create content