02-13-2007 09:04 PM - edited 03-03-2019 03:44 PM
I installed 1 2MFT VWIC card in 2821 router if I command sh ver I see this card detect but sh run command I can?t see it any controller how can I enable it for E1 configuration
Thanks
robin
02-13-2007 09:18 PM
Hi Robin
Can you post the output of show version here ?
Also have you tried configuring card type e1 ?
regds
02-14-2007 05:05 AM
Hi friend,
I think you are using a version 2 card.
In this case you require the following command
(config)#card type e1/t1
eg. card type e1 0 1
HTH, rate if it does
Narayan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide