Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

E1 flaps brings down the entire multilink to hung

Hi All,

In our network we are running MLPPP on major locations. The problem that we are facing is when any one of the E1 bundled in multilink flaps, the multilink got hung. The multilink stays up but we are not able to ping the other end /30 ip. In those cases, we have to remove the flapping link from the multilink. If we fail to remove the flapping link from multilink then we have to do a shut/no shut on the multilink interface to bring the services up.

I would like to know

a. Is the expected behavior in multilink?

b. Is there any workaround apart from shut/no shut.

Kindly revert.

Thanks

Arun Kumar

2 REPLIES

Re: E1 flaps brings down the entire multilink to hung

We had a similar issue with multilink. We used to do a clear interface multilink to restore it

IOS upgradation of the routers however resolved the issue

Narayan

Bronze

Re: E1 flaps brings down the entire multilink to hung

Hi Narayanan,

Thanks for the response. Could you please provide to which IOS you upgraded.

I am facing this problem in 7200 series router running with 12.3 (14)T7 and 12.3 (8)T8.

thanks in advance

Arun Kumar

142
Views
0
Helpful
2
Replies