Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

e1 is not responding

Dear,

I have MWR1941 router . This router has VWIC-2MFT-E1DIR. It has a default y cable configuration. My problem is associated with e1 . MY card is not sending any singnal. Please advise.Pls check the sh controller and sh run

5 REPLIES

Re: e1 is not responding

The controller shows loss of frame.

Make sure the framing matches at both ends. Try chnaging it to framing no-CRC4 under the controller confguration and test

Narayan

Hall of Fame Super Gold

Re: e1 is not responding

There are also loopbacks on the line and because this appears to be a professional installation for mobile neetwork, you probably have a maintenance department that should look into that.

Community Member

Re: e1 is not responding

Dear Narayan,

Now I ahve no option to do your test. I am sending another attached file . pls advise.

Re: e1 is not responding

Still loss of frame.

also saw alarm incoming signal as well. You need to check the parameters at both ends

Narayan

Community Member

Re: e1 is not responding

Dear Narayan,

I have solved the problem yesterday night and sorry inform you. I had to reconfigure it.

Bikash

114
Views
0
Helpful
5
Replies
CreatePlease to create content