Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 ISDN-PRI

It must router 3845 and I buy a card VWIC2-1MFT-T1/E1, when configure the controller (Pri-Group timeslot 1-31) leaves a message "Not enough DSP resources available", is required to have DSP so that it works like a contingency ISDN for data. The IOS is ip-voice 12.4T, thanks

6 REPLIES
Hall of Fame Super Gold

Re: E1 ISDN-PRI

Hi, load a non-voice image like ipbase and you will be able to configure PRI as for data only.

Hope this helps, please rate post if it does!

New Member

Re: E1 ISDN-PRI

It is necessary to have installed DSP.

Hall of Fame Super Gold

Re: E1 ISDN-PRI

As mentioned above, when you load an image without voice support, you will be able to do data isdn pri without dsp. Else, you will need to have dsp.

Hope this helps, please rate post if it does!

New Member

Re: E1 ISDN-PRI

It is possible to be config without DSP to receive calls ISDN and to raise data by contingency from a remote ISDN-BRI.

The command ISDN TEST CALL INTERF s 0/2/0:15

and debug. the message received is:

ISDN Se0/2/0:15 **ERROR**: call_setup_ack_proceeding: NO HDLC available b channel 14 call id 0x8009

New Member

Re: E1 ISDN-PRI

I have PVDM.

Hall of Fame Super Gold

Re: E1 ISDN-PRI

Which exact IOS are you running?

This is how you configure for integrated data and voice on isdn PRI:

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/intserv.html

Note I recommend you use 12.4(11)XJ4 for that.

As a recognition to those providing answers, please rate useful posts with the scrollbox below!

226
Views
0
Helpful
6
Replies