Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 Multilink Group Load Balance

Hi All,

I'm trying to load balance 4 X E1 Connection to the same router. Currently it's running on 1 multilink group. I tested in Lab to break the 1 multilink group into 2 multilink group and it doesn't work.

Then 2nd multilink group simply does not go up. I'm trying to load balannce the connection, that's why i break it into 2 multilink group.

It's there any other way?

Thank

2 REPLIES

Re: E1 Multilink Group Load Balance

Hi

You need to make sure that the multilink config is done on both the end points. untill unless you replicate the same on both the ends you wont be able to get your link up.

if the links are connecting onto the ISP end you need to make sure that the ISP also replicates the config out there. if the links are terminating onto your remote end make sure you do the config changes out there as well..

regds

Super Bronze

Re: E1 Multilink Group Load Balance

The whole idea of multilink is to load balance. Why do you believe the 4x wasn't doing so? (Link balance can be somewhat off depending on how multilink transmits packets down multiple links. Balance can be sometimes improved with multilink fragmentation.)

158
Views
0
Helpful
2
Replies