Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 PRI and codecs

Hi Guys

here is my diagram

PBX--E1---Router1---E1---Router2--E1-PBX

I set codec G729 for pbx calls to user more bandwidth.

so should I do any configuration for passing this coded between R1 and R2?

or the router r1 acts with them as data?

1 REPLY
New Member

Re: E1 PRI and codecs

Hi,

You can set G729 as the preference on the dialpeer. For example.

dial-peer voice 11 voip

description #To R1#

destination-pattern 1....

session target ipv4:1.2.8.8

dtmf-relay h245-alphanumeric

codec g729ulaw

263
Views
0
Helpful
1
Replies