Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

E1 PRI

Is this configuration correct for a data transfer from an E1 PRI

!

controller E1 1/0

framing NO-CRC4

pri-group timeslots 1-31

!

!

interface Serial1/0:15

ip address 192.168.150.34 255.255.255.224

no cdp enable

encapsulation ppp

dialer idle-timeout 119

dialer string xxxxxx

dialer-group 1

isdn switch-type primary-net5

isdn point-to-point-setup

ppp authentication chap pap callin

ppp chap hostname yyyyyyyy

ppp chap password zzzzzz

!

dialer-list 1 protocol ip permit

1 REPLY

Re: E1 PRI

Hey,

One question, if you want the entire 30 Channels to be dialed in simultaneously to the same destination why not use it as a E-1 rather than E-1 PRI.

I mean what is the need of PRI, if you can manage the same show with Channelized E-1 or E-1.

Otherwise in this config, I guess it should be fine.

117
Views
0
Helpful
1
Replies
CreatePlease to create content