Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 Software loop

Hello,

I have a VWIC-2MFT-E1 on a 2800 router.

I have to set up a software loop on the router to check the two E1 links (channelized). Would someone know how to set up a soft loop to test the E1 links.

Regards.

3 REPLIES
Hall of Fame Super Gold

Re: E1 Software loop

All the loop command are configured under controller. You can loop the line toward the circuit, the router, etc.

Hope this helps, please rate post if it does!

Re: E1 Software loop

I vaguley remember the commands, try below:

Controller E1 X/Y

E1 N loopback local

HTH

Sam

New Member

Re: E1 Software loop

Conf t > Controller E1 X/Y/Z > loopback local line

713
Views
6
Helpful
3
Replies