Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 to WIC

Hi ,

There is a Channelised E1 output which is from mux . as my controller port is faulty can i connect this outout of e1 ( RJ45) to 2mb modem ( RAD ASM)(using WIC in router) and get the link through ?

Actually i tried it and failed .. is there any suggestions ?

4 REPLIES
Hall of Fame Super Gold

Re: E1 to WIC

Can you describe again what is that you want to connect and where ?

Silver

Re: E1 to WIC

kindly check the switch setting at modem end.

regards

shivlu jain

New Member

Re: E1 to WIC

If I understand the setup correctly, you will require a RAD convertor modem as the output that you are getting is G.703 which needs to be converted to V.35

Hall of Fame Super Gold

Re: E1 to WIC

The problem is that is not really clear what the OP wants to do.

Cisco routers have G.704/G.704 natively with the right cards and need no converters.

141
Views
1
Helpful
4
Replies
CreatePlease to create content