Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 voice and data

Hi,

I need an urgent solution. We implemented an E1 link for a client with a Radio link for redundancy on our mpls vpn.

However data traffic doesn't pass over the E1 link. However the Radio link supports both.

My configurations have been check on both the e1 controller and the serial interface. farming is crc4, channel-group 0 timeslot 1-34 speed 64 have also be configured appropriately.

Do you have any suggestions as to why data traffic is not passing through the E1 link?

Thanks

2 REPLIES

Re: E1 voice and data

Hi

Timeslots cannot be 1-34.

Can you give "sh run" and "sh int" output?

Regards

JD

New Member

Re: E1 voice and data

i also believe the timeslots are wrong. it can be either 0-31 or 1-32. chack with the service provider or else try configuring both one at a time, to see which one works.

Thanks

114
Views
0
Helpful
2
Replies