Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 WAN

How to setup the E1 WAN for data only with cisco 2951 routers and 2-port 3rd Gen. MFT E1 cards?

I need the complete IOS configuration for above routers.

 

Thanks.

Everyone's tags (1)
2 REPLIES
New Member

Hi Exploited,You'd need to

Hi Exploited,

You'd need to provide a lot more information for a meaningful answer.

Are you using IPv4 or IPv6 on the network?

Figure out what transport protocol your going to be using, is this a fully meshed WAN link? Hub and Spoke? Point to Point? What routing protocol are you using? EIGRP? OSPF? BGP?

New Member

 Hi Micheal,Here are answers

 

Hi Micheal,

following are the answers to your queries

IPv4 Class A private IP addressing

Point to Point, Hub-and-spoke topology

Planned to use EIGRP

 

 

35
Views
0
Helpful
2
Replies