Ed makes a good point about why the configured enable password is not working. But this does not address the fundamental issue of the original post which asks about how to have a user go directly to enable mode without requiring use of the enable password. There are 2 approaches to accomplish this:
- if you want some users to go directly to enable mode and other users to be jsut in user mode then you need to also have configured aaa authorization to do local authorization.
- if you want all users to go directly to enable mode then you can configure privilege level 15 on the vty lines and console port.
Thanks for the follow-up. I thought from previous use that a (local) user with privilege level 15 would immediately enter "privileged exec" mode upon login. However, I may have confused that with a system I'm currently using that has RADIUS authentication with priv-level 15 authorization automatically enabled. I'll have to confirm this later today to refresh my memory. Sorry to the OP if I misled you on the original question.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.