Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

EBGP-Multihop value

Dear All

What i know is if you there is 2 routers established EBGP via loopback address and the command {neighbor ip-address ebgp-multihop} used without speciying any ttl value in the ebgp-multihop command it's gone working because the default value is 255 and it's enough to reach the remote peer loopback BUT there is many Q in testking and alot of resources said that is wrong so could anybody confirm with me

Best Regards,

Mounir Mohamed

  • WAN Routing and Switching
1 REPLY
Cisco Employee

Re: EBGP-Multihop value

It is usually a good idea to limit the TTL to a minimum. This prevents the eBGP session to get established via an unexpected path.

Hope this helps,

88
Views
0
Helpful
1
Replies
This widget could not be displayed.