Right now I'm using the maximum-paths command under my bgp router configuration to leverage both circuits we have to our Provider. However, the return or receive traffic is not being load balanced at all. Would using loopbacks and multihop to peer with the PE overcome this limitation of load balancing return traffic, or is the same issue apparent with the multihop loopback scenario?
probably your ISP is not using maximum-paths on its side.
The configuration of eBGP multihop with a loopback has the advantage that requires symmetrical configuration to work well but I would first ask them if they have maximum eibgp-multipaths under address-family ipv4 vrf vrf-name.
The SP said the maximum-paths is in place under our vrf, and that the lopsided usage is probably a result of a few hosts creating flows that consume much of the bandwidth on one link. The flows are load balanced, but if a host downloads a large file over one of the 1.5 mb linksg, that flow won't be broken up. It will stay on the same link. He suggested perhaps using route maps to break up the traffic after identifying the top talkers. I guess I would need to use route maps with access lists and as path prepending. A little ugly. Anyone have any other suggestions?
No, i can't see how that would affect the return traffic path. Multi-hop is purely used when the interface used for the BGP peering is not directly connected.
If you want to influence how traffic is coming in you can look at either
1) MED - where you give a weight to the networks you are advetising out so you advertise alll networks out of both routers but split them in half in effect and on router1 give preference to first half and on router2 give preference to the second half. If one router/link goes down all traffic comes in the other link.
MED is only effective between you and your ISP ie. the preferences you set do not extend beyond the ISP
2) AS Path prepending. This allows you to give preference to networks beyond your local ISP.
I don't think so I think Bill is referring to a case where you build a single eBGP session on loopbacks and you have two static routes over two parallel links that provide reachability of the other router loopback.
If you do so on both sides you use recursion and you use both links according to CEF or other load-sharing.
My impression is that on the other side the current configuration is not using the correct version of bgp multipaths in af ipv4 VRF vrf-name
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...