Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Egress & Ingress policy on HWIC - is it possible ?

Hi everyone,

I own router 3845 with 2x1GB ports and one Serial,

Today i implmented very strict QoS service polciy using NBAR and other classic QoS parameters for both inbound and outbond traffic, using MIR/CIR and etc etc..

It is workig great and do the job

however it only support on Gig0/0 And Gig0/1

As well on the Serial

I have additional 4 Ethernet Ports using

HWIC-4ESW interface and it seems that the interface doesnt support the service-policy output feature

Which interface should i purchase that capable of service-policy both out and in

I think NM-4FE will work (i hope so) may someone confirm ?

1 REPLY
Cisco Employee

Re: Egress & Ingress policy on HWIC - is it possible ?

Hello,

I have checked it very briefly on one of my routers - it's a 2801 running c2801-advipservicesk9-mz.124-4.XC2 IOS and having the HWIC-4ESW installed. I was able to install an empty policy map in the outbound direction on the HWICs port.

Does the router complain about something when the policy-map is applied? If possible, paste it here.

Best regards,

Peter

160
Views
0
Helpful
1
Replies