In EIGRP, the FD being set to infinity means that the route has been learned via EIGRP but at the same time, it is known from another source that is more trustworthy, so the learned route can not be used. Notice that in your case, the network is both learned via EIGRP, and at the same time, redistributed from static routes on your own router into EIGRP. In this case, the static route is considered more trustworthy, as its administrative distance is 1, so the EIGRP-learned route won't make it into the routing table. That is the reason for having the FD set to infinity to explain that the EIGRP-learned route is currently unusable.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...