Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

eigrp hub and spoke question

hi,

I,m working with gns3 to setup a test environment.

3 routers, 2 of them are hubs and the last one is a spoke.

with the 2 routers I'm just giving a default route to my spoke which is also just a stub router. then the stub is simply pushing to the hubs a summary.

now what I would like to do with the hubs is decide if on the spoke tunnel0 or tunnel1 gets used. right now they both have the same priority but I would like to be able with the hubs to make that decision.

so basically on hub I change something and it makes spoke #24 use tunnel 0 to hub 1 instead of tunnel 1 to hub 2.

hope I,m clear

also if possible please give me an example.

thanks.                  

Everyone's tags (3)
2 REPLIES
Bronze

Re: eigrp hub and spoke question

now what I would like to do with the hubs is decide if on the spoke tunnel0 or tunnel1 gets used. right now they both have the same priority but I would like to be able with the hubs to make that decision.

so basically on hub I change something and it makes spoke #24 use tunnel 0 to hub 1 instead of tunnel 1 to hub 2.

###ds How are sending the default from hub to spoke? Summaries? Redistributed locally? Propagated from elsewhere?

Sent from Cisco Technical Support iPad App

New Member

Re: eigrp hub and spoke question

Have you tried changing the delay on your tunnel interfaces to make one route look better than the other?

Sent from Cisco Technical Support iPad App

339
Views
0
Helpful
2
Replies
CreatePlease to create content