Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Eigrp issues

I am installing two 3845s with ATM and FrameRelay,at two Hub sites, replacing two 3825s. 40 Remote sites connect to both Hub 3845s. 1 primary PVC, 1 backup pvc. EIGRP neighbors keep resetting the hold uptime, about every minute. Putting the original 3825 back in at the primary Hub site fixes this problem. WAN circuits/interfaces check out fine, no errors. Is there a bug in EIGRP? ios ver on new 3845s is 12.4-9.T7. All the remote sites are 2500 series, 2600 series routers. Not sure why I can't get the neighbors uptime to stay up. Thank you.

2 REPLIES
Hall of Fame Super Silver

Re: Eigrp issues

Hello Paul,

there was another thread about a similar scenario.

Check your MTU settings on both ends the new hub and the remote sites

EIGRP updates have different sizes depending on the the prefix len : prefixes longer more specific then >= 24 use more bytes.

This makes possible cases where there is a problem in sending some updates and EIGRP neighbors keep resetting.

Hope to help

Giuseppe

New Member

Re: Eigrp issues

Thank You Giuseppe

We will implement these changes next week.

We appreciate your help!

107
Views
0
Helpful
2
Replies