I am confused in regrading Eigrp load balance. please clear me my confusion.
I have Ho router which connect another BR. from Ho to Br has 3 link. example
E=HO and A=BR
Â· E-B-A with a metric of 30
Â· E-C-A with a metric of 20
Â· E-D-A with a metric of 45
Now my question is>
1. If I run Eigrp then by default equal load balance and with 3 link data is transfer same time to go destination Br? or only data transfer E-C-A ?.
2. If I use variance 2 then EIGRP provide unqual load blance link path
E-B-A and E-C-A.
so my confusion is at first normal eigrp run then 3 link use for data transfer to go destination A and when I want only two link use for data transfer to go destination A same time then I use Variance ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...