Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

EIGRP load balancing over T1 Point to Point Circuits

3 questions. The third is the most important.

1. I have 2 circuits connected to the same 2811 router (pairs), how can I configure EIGRP to load balance the traffic?

2. I have 1 Circuit in each of 2 seperate 2811 Router (pairs) How can I configure these to balance the traffic?

3. I have 2 Circuits in each of 2 pairs of 2811 routers, how can I load balance accrossed all 4 circuits.

Thanks, Jack

1 REPLY

Re: EIGRP load balancing over T1 Point to Point Circuits

This should be achieved easily by configuring all links with the same bandwidth. EIGRP will then automatically load-balance between identical circuits. I think that you can use eigrp variance to account for the difference caused by the local LAN hops:

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009437d.shtml

even more info on eigrp load balancing:

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094820.shtml

and

http://www.cisco.com/en/US/tech/tk365/tk207/tsd_technology_support_sub-protocol_home.html

Hope this helps you out.

Regards,

Leo

264
Views
0
Helpful
1
Replies
CreatePlease to create content