Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

eigrp -Multipoint FR

dear all,

i have configured eigrp topology diagram as per attachment, i am not able to ping 5.5.5.5 from R4 but its showing in the topology table.

i have configured "no ip split-horizon eigrp 1" on multipoint on R1,

please advice...

3 REPLIES

Re: eigrp -Multipoint FR

Make sure you have ALL the correct frame-relay mappings.

New Member

Re: eigrp -Multipoint FR

yes i am able to ping from R4 to R1 and R5 to R1 and vice-a-versa but i have not configured mapping between R4 and R5 on FR sw, may be, this not reqd i suppose, because it must route via R1..

is this correct?

New Member

Re: eigrp -Multipoint FR

issue has been solved thanking you...

103
Views
0
Helpful
3
Replies