I have a RSM and a Cat 4k L3 switch seperated by the RSM's switch. I keep getting bounces on certain vlans that have HSRP set up on them. Other vlans with HSRP have no issues. All HSRP is set up between these 2. Anyone have any clues as to what is going on?
the title of your post says that your EIGRP neighbors are bouncing, in the description of your problem, you talk about HSRP, can you clarify that ?
If it is HSRP you are having problems with, there could be numerous reasons, one of them being that the HSRP peer misses three successive HSRP hello packets from its corresponding HSRP peer, either due to physical or spanning tree problems.
Have a look at the document below, it contains a fairly comprehensive overview of approaching HSRP issues:
Understanding and Troubleshooting HSRP Problems in Catalyst Switch Networks
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...