I am not clear why you think this might be a temporary effect or why you think that behavior might change if no auto-summary were configured a second time. I have never seen a router that needed this command to be entered a second time in order for it to take effect.
The summary route is created by auto summarization or by manual summarization. I would guess that these routers are configured with summary-address on some interfaces. If you would post the output of show ip protocol it would help us to understand this. Even better would be to post the router configs so that we can see what is going on.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...