I need to connect my network to the Telco over MPLS. I have 10 Branches connecting to my HQ. I am running EIGRP at my network, i want to connect the Network to the Telco's MPLS. Telco is runnig BGP on the network, i want to know how to connect / re-distribute my private network (EIGRP Network) over the BGP.
My scenario is i have a HQ running two 7200 router, (redundant) and need to get connect to the Branches using IP-VPN over MPLS (like hub design).
All bracnh offices will have one router (2811) connecting to HQ. i want to know what to be configured on my routers to connect these offices, keeping EIGRP on my network or even replacing EIGRP with static routing.
on brancehs i have 2800 series router i have only one network at each branches (Branch 1 - 192.168.200.x/24
Branch 2 - 192.168.201.x/24 ...)
Can i run and redistribution both BGP and EIGRP on the HQ and the branch office 2811 small router. how to do the redistribution in this case?
At the remote sites you will only need BGP and a static route (I use the default route to point to the MPLS cloud). BGP requires that all advertised subnets be in the routing table. Since all the routes are locally connected, they are in the table. Even if you configure EIGRP, it will not have any peers and thus creates unneeded overhead. At the head end you will still need to use EIGRP and BGP and redistribute between the two (as the others stated). Here's a redistribution example-
router eigrp 1
redistribute bgp 65001 route-map bgp2eigrp
ip access-list standard bgp2eigrp
remark Permit Green Bay Private Subnets
permit 126.96.36.199 0.0.0.255
remark Permit Green Bay Private MPLS Network
permit 188.8.131.52 0.0.0.3
remark Permit Appleton Private Subnets
permit 184.108.40.206 0.0.0.255
remark Permit Appleton Private MPLS Network
permit 220.127.116.11 0.0.0.3
route-map bgp2eigrp permit 10
match ip address bgp2eigrp
set metric 1000 1 255 1 1500
You may also want to use prefix lists to filter what routes are allowed into BGP.
You only have a single router at the remote sites correct? If so, then you do NOT need to redistribute BGP. BGP will be your only routing protocol at the site. No EIGRP. Yes the default route will point to the cloud.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.