Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EIGRP problem

Hi experts,

can any one tell me how can we get EIGRP third AD-5 and wat all configuration is needed plz explain it to me in configuration commands if possible.

thanks in advance

6 REPLIES
New Member

Re: EIGRP problem

Hi Sandy,

EIGRP will have a third AD-5 whenever there is summarization done by EIGRP.

Silver

Re: EIGRP problem

AD 5 is for summarized routes. Here an example:

For topology displayed in the picture, to have summary route with AD 5 appear on R4, type this on R3:

(config)interface eth0

(config-if)ip summary-address eigrp 192.168.0.0 255.255.254.0

Hall of Fame Super Silver

Re: EIGRP problem

Pavlo

Yes AD of 5 is for EIGRP summarized routes. And it is local to the router that does summarization. Unless I am misunderstanding something, if you summarize on R3 then R3 will have AD of 5 but R4 will have normal AD for those routes.

HTH

Rick

Re: EIGRP problem

Rick,

By "normal", is that 90 or 170? I presume it would be 90, wouldn't it?

Kevin Dorrell

Luxembourg

New Member

Re: EIGRP problem

hi all,

yes rick ur right AD-5 will be shown on the router where summarization is done not on R4 i have done that thanks rick i have done theory but i was unable to do it practically thanks once again

regards,

sandeep

New Member

Re: EIGRP problem

hi all,

yes rick ur right AD-5 will be shown on the router where summarization is done not on R4 i have done that thanks rick i have done theory but i was unable to do it practically thanks once again

regards,

sandeep

139
Views
10
Helpful
6
Replies
CreatePlease to create content