EIGRP problem

[sandy3006]

Hi experts,

can any one tell me how can we get EIGRP third AD-5 and wat all configuration is needed plz explain it to me in configuration commands if possible.

thanks in advance

[saimbt]

Hi Sandy,

EIGRP will have a third AD-5 whenever there is summarization done by EIGRP.

[Pavel Bykov]

AD 5 is for summarized routes. Here an example:

For topology displayed in the picture, to have summary route with AD 5 appear on R4, type this on R3:

(config)interface eth0

(config-if)ip summary-address eigrp 192.168.0.0 255.255.254.0

[Richard Burts]

Pavlo

Yes AD of 5 is for EIGRP summarized routes. And it is local to the router that does summarization. Unless I am misunderstanding something, if you summarize on R3 then R3 will have AD of 5 but R4 will have normal AD for those routes.

HTH

Rick

[Kevin Dorrell]

Rick,

By "normal", is that 90 or 170? I presume it would be 90, wouldn't it?

Kevin Dorrell

Luxembourg

[sandy3006]

hi all,

yes rick ur right AD-5 will be shown on the router where summarization is done not on R4 i have done that thanks rick i have done theory but i was unable to do it practically thanks once again

regards,

sandeep

[sandy3006]

hi all,

yes rick ur right AD-5 will be shown on the router where summarization is done not on R4 i have done that thanks rick i have done theory but i was unable to do it practically thanks once again

regards,

sandeep