Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EIGRP & Redistribution Querry

Hii,

Want to confirm the following from you :-

1) What are the different states of EIGRP. What are the function of each of them.

2) What is the default metric while re-distributing BGP into RIP.

Regards

3 REPLIES
Hall of Fame Super Silver

Re: EIGRP & Redistribution Querry

Hello Sam,

2) there is no default seed metric in EIGRP you need to set one with

metric BW delay reliability load mtu

example

router eigrp 100

metric 10000 1000 255 1 1500

red bgp 200

!

otherwise no BGP routes are redistributed into EIGRP

1)

not clear I try to guess:

sh ip eigrp topology shows the states of routes

normal good state is passive.

a route goes active if current best route failed no feasible successor exists and the router sends Queries to all of its neighbors about the prefix.

there is also the EIGRP neighbor state machine to setup EIGRP adjacencies.

this can be seen with

sh ip eigrp neighbors

Hope to help

Giuseppe

New Member

Re: EIGRP & Redistribution Querry

Hello Guislar thanks...

For point 2..

I was requesting for "default metric while redistributing BGP into RIP"

But You replied for "Redistribution of BGP into EIGRP".

Hall of Fame Super Silver

Re: EIGRP & Redistribution Querry

Hello Sam,

you are right

with RIP you can set a seed metric with a scalar value (single integer)

router rip

default-metric 2

red bgp 200

see

http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_rip.html#wp1011085

Hope to help

Giuseppe

111
Views
0
Helpful
3
Replies
CreatePlease to create content