Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

eigrp redistribution

dear all

if i am going to redistribute a routing protocol into eigrp, and i have a delay metric of 2ms how i am going to insert it in the redistribution command the dealy of the interface is a unit of 10-micros second as cisco tell, please help

1 REPLY
Purple

Re: eigrp redistribution

Hi,

The redistribute command for EIGRP takes a delay parameter in 10s of microseconds. Therefore, for a delay of 2ms, you need to set the delay parameter to 200. That means 200 x 10 microseconds, which gives you 2 seconds.

Paresh

PS> Pls do remember to rate posts.

103
Views
0
Helpful
1
Replies